Dear all, Following are the highlights of the Tuesday ( 12th April) meeting. 1. Regular maintenance of test benches, which was to be taken up from this week, is postponed. It will be taken up, perhaps, from next week. 2. While magnetic measurements ( e.g. MM2) are in progress, try to keep a watch on display. This to ensure that there is no alarms on coil rotation ( Parameter highlighted in RED for alarm). Incase an alarm is encountered on coil rotation; the measurement be stopped to prevent damage to shaft. 3. It is advised to handle the magnet Polarity Mechanism very gently. To prevent any damage to it, operators familiar with the polarity changing mechanism only should try. However, efforts are on to make the mechanism easier. Till then new operators may take the help of experienced. 4. When a magnet arrives on bench with out label or with wrong label, apart from generating NC, a message be sent to Mr. Vittorio Parma. He can be contacted on 79183, 72756, Mobile: 163302, Vittorio.Parma@cern.ch. Have a nice day With regards Adibabu